Installing Intermediate Flange - BMW K 1200 LT 1999 Repair Manual

Installing intermediate flange

Installing freewheel
•
Oil the needle roller bearing well.
•
Insert the freewheel into the crankcase helical-
cut gear first.
Installing countershaft
e
Caution:
Insert the spring so that the large external diameter
(arrow) projects upwards and is pre-loaded against
the freewheel gear.
•
Insert the countershaft into the crankcase with
the small gearwheel facing down.
Installing intermediate flange
•
Check that sealing face is clean and degreased
and apply a thin coat of Omni VISC 1002, see
black line on sealing face with grey shading.
•
Fill the expansion groove (arrow) with sealing
compound.
KR110690
L
Note:
Remove excess sealing compound with a spatula.
•
Install the intermediate flange (with locating slee-
ves).
•
Use Torx socket T 30, BMW No. 00 2 600, to
tighten the screws.
X
Tightening torque:
Intermediate flange......................................... 9 Nm
Installing output shaft sealing ring
L
Note:
Clean the sealing ring seat. Oil the sealing ring and,
with the aid of a guide, slip it onto the drift.
•
Drive in shaft sealing ring with drift,
BMW No. 11 1 630, and handle,
BMW No. 00 5 500.
KL110270
11.39