Final inspection and function check
•
Fill up with fuel.
•
Check engine oil when engine is cold, top up if
necessary.
•
Check clutch.
•
Check gear shift action.
•
Check reverser.
•
Check handbrake and foot brake
•
Check lights and signalling equipment:
–
Front and rear parking lights
–
Low and high headlight beams, headlight flasher
–
Brake light (check front brake and rear brake
separately)
–
Turn signals left/right
–
Hazard warning flashers
–
Horn
–
Telltale and warning lights
–
Instrument lighting
–
Instruments
–
Cockpit lighting
–
Case lighting.
•
ABS: perform starting test. Both ABS warning
lamps must go out when the motorcycle is trav-
elling at speeds over 5 km/h (3 mile/h).
•
Radio and remote control front/rear.
•
Check optional extras, as applicable:
–
Cruise control
–
On-board computer
–
CD changer
–
Seat heating.
•
Trial run if necessary
•
Place documentation and engine oil filler funnels
in the compartment in the top case lid.
•
See "Inspecting motorcycle for damage" if any-
thing is not in order.
•
Confirm pre-delivery check in Service and Tech-
nical Booklet.
Final cleaning
•
Clean the motorcycle.
L
Note:
Do not use a steam or high-pressure water jet. The
high steam or water pressure could damage seals,
the hydraulic system or electrical components.
00.37