Checking headlight beam angle,
adjusting if necessary
Vertical adjustment
•
Set suspension preload to "LOW" (turn counter-
clockwise).
L
Note:
Make sure that the adjuster on the instrument-panel
cover is at the "UP" position (turned counter-clock-
wise as far as it will go).
•
If necessary, turn the adjuster on the instrument-
panel cover counter-clockwise as far as it will go.
1
•
Manually adjust the headlight beam throw by
turning the adjusting screw (1) beneath the fai-
ring upper section with the aid of the headlight
tester.
Setting for headlight beam angle adjuster
....... .-10 cm (-3.94 in) at a distance of 10 m (32.80 ft)
Turned to left............................ longer throw/higher
Turned to right ......................... shorter throw/lower
•
Adjust the suspension preload.
Lateral adjustment
KL630010
•
If necessary, laterally adjust the headlight beam
angle by turning the adjusting screw (2) at the top
left of the headlight with the aid of a cross-reces-
sed screwdriver.
KLPD0080
2
KR630060
63.7