BMW K 1200 LT 1999 Repair Manual page 178

Removing and installing exhaust
heat shield
•
Slacken screws securing front left footrest plate.
•
Remove the 2 retaining screws (arrows).
e
Caution:
Do not damage the side case when removing the
heat shield: use masking tape to protect the case if
necessary.
•
Pull heat shield toward rear to remove.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
•
Engage tab at front in bore (arrow) in main frame.
X
Tightening torque:
Footrest plate to frame ................................. 21 Nm
Removing and installing exhaust
system
– Remove left-hand section of engine spoiler.
....................................................See Group 46
a
L
Note:
The bottom fastener of the rear footrest plate is se-
cured to the battery bracket. When removing the
battery cover, slacken but do not remove the screw.
– Slacken screws securing rear left footrest plate.
– Remove left trim panel and battery cover.
– Remove front footrest plate.
KL180010 KL180010
•
Release the cable tie for the oxygen
sensor (arrow).
•
Disconnect plug for oxygen sensor (1) and pull
cable down to remove.
•
Remove exhaust heat shield.
KL180040
•
Remove screws (arrows) of exhaust bracket and
remove exhaust bracket.
1
KL610070
KL180030
18.5