Removing and installing switch for
gear indicator
–
Remove left side section of fairing.
....................................................See Group 46
a
–
Remove the left-hand battery cover.
–
Remove cross-tube.
•
Disconnect plug (1).
•
Open cable ties (arrows) and pull cable down to
remove.
e
Caution:
The spring retainer could damage the switch hous-
ing if it jumps out: slowly relieve the tension on the
retainer.
•
Compress the ends of the spring
retainer (arrows) and pull the gear indicator out
toward the rear.
•
Installation is the reverse of the removal proce-
dure.
1
KL610201
KR610190
Removing and installing power
socket
Socket on engine spoiler
–
Remove left-hand side of engine spoiler.
....................................................See Group 46
a
2
•
Release the fastener (2) and take off the power
socket.
•
Installation is the reverse of the removal proce-
dure.
Socket in top case
–
Remove the top case.
....................................................See Group 46
a
3
•
Release 2 fasteners (arrows) and remove
cover (4).
•
Disconnect plug (3).
•
Release the fastener (5) and take off the power
socket.
•
Installation is the reverse of the removal proce-
dure.
X
Tightening torques:
Top case to rear frame ................................... 9 Nm
KL610280
4
5
KL610290
61.23