Removing And Installing Ignition Switch/Steering Lock Cable; Removing And Installing Fanfare Horn - BMW K 1200 LT 1999 Repair Manual

Removing and installing ignition
switch/steering lock cable
– Remove left and right fairing side sections.
d
Warning:
Comply with safety precautions when handling or
working with fuel.
– Remove fuel tank.
1
•
Carefully remove the sealing lacquer from the
tapped bore for grubscrew (1).
•
Remove the grubscrew.
•
Pull housing of ignition light switch (2) with cable
down to remove.
3
•
Open the cable ties (arrows).
•
Open the lid of the electronics box.
•
Disconnect plug (3).
•
Remove ignition light switch housing.
61.22
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
•
Seal the tapped bore for the grubscrew with
sealing lacquer.
•
Carefully route the cable and secure in position
with cable ties.
•
Make sure that the seal in the cover of the elec-
tronics box is correctly seated.
Removing and installing fanfare
horn
– Remove left and right fairing side sections.
....................................................See Group 46
a
– Remove upper section of fairing.
5
4
2
KR610340
9
•
Disconnect plug (4, 6).
L
Note:
Do not slacken the fastener securing the fanfare
horn to the retaining plate (8, 9).
•
Release fasteners (5, 7) and remove fanfare horn
complete with retaining plates (8, 9).
•
Installation is the reverse of the removal proce-
dure.
X
Tightening torque:
Retaining plate for fanfare horn
to fairing bracket .......................................... 21 Nm
KL610150
7
6
8
KL610321