9
2
1
Installing dampers
•
Insert the rubber dampers (7) into the damper
housing (6).
L
Note:
New parts must be oiled lightly.
•
Push the retaining plate (4) onto the output
shaft (3), slightly heat the inner part of the
damper (5) and press it into position on the shaft.
•
Push the damper housing on to the output shaft.
Assembling engine
1100
Installing output shaft
•
Push on circlip (2) and needle roller race (1).
•
Place the output shaft in the crankcase.
2
8
L
Note:
Make sure that the gap of the circlip (arrow) is facing
downward in the crankcase.
•
Install O-rings (8, 9) for the water and oil passag-
es.
11.36
4
3
Assembling the crankcase
•
Check that sealing face is clean and degreased
and apply a thin coat of Omni VISC 1002, see
line on sealing face with grey shading.
•
Fill the expansion groove (arrow) with sealing
compound.
L
Note:
Scrape off excess sealant with a spatula.
9
KR110521
6
5
7
KR110451
KL110250