1
33 1 510
•
Position rear wheel drive with retaining fixture,
BMW No. 33 1 510, upright.
e
Caution:
To prevent the input bevel pinion (1) from being
damaged if it falls out, use a soft underlay.
•
Heat bearing seat to 120 °C (248 °F).
•
Remove input bevel pinion (1).
L
Note:
If necessary, lightly tap input bevel pinion (1) to re-
lease.
•
Remove shim (2) from housing.
33.10
Disassembling input bevel pinion
j
120
KR330070
•
Clamp input bevel pinion (1) into vise with pro-
tective jaws (splines facing upwards).
•
Using puller, BMW No. 00 7 500, pull off both
bearings at the same time.
2
•
Take off radial-thrust bearing (6), roller bearing
cage (5), outer race (4) and inner race (3).
KR330400
00 7 500
3
4
5
KR330100
6
KR330130