Checking/adjusting ABS sensor gap
Checking ABS sensor gap
3
•
Align the marked point on sensor ring (1) with
ABS sensor (2).
•
Use ABS feeler gauge (arrow) to check the gap
between the ABS sensor and the sensor ring.
Adjusting ABS sensor gap
•
Slacken ABS sensor.
e
Caution:
After adjusting, check clearance of the ABS sensor
round the entire circumference of the sensor ring.
•
Adjust sensor gap with spacing plate (3) and re-
check.
ABS
sensor gap ......... 0.45...0.55 mm (0.018...0.022 in)
X
Tightening torque:
ABS sensor mount ........................................ 4 Nm
Removing and installing rear brake
master cylinder
e
Caution:
1
Do not allow brake fluid to come into contact with
painted parts of the motorcycle, because brake fluid
destroys paint.
2
–
Drain the brake system.
–
Remove right footrest plate.
KL340100
L
Note:
Mark installed position of brake hose (5) relative to
brake master cylinder.
•
Remove screws (6) and remove brake master
cylinder.
•
Open non-reusable hose clip (7) and disconnect
return hose (4).
•
Use an open-ended wrench to hold at the
flats (arrow) and disconnect brake hose (5).
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
•
Tighten new non-reusable hose clip (7) with pli-
ers, BMW No. 13 1 500.
•
Check and, if necessary, adjust play at piston
rod.
X
Tightening torques:
Master cylinder to footrest plate ..................... 9 Nm
(clean thread + Loctite 243)
Brake hose to brake master cylinder ............ 18 Nm
Footrest plate to frame ................................. 21 Nm
KR340350
4
7
5
6
KL610100
34.13