Removing And Installing Locking System For Front Seat; Removing Locking System; Removing And Installing Bowden Release Cable - BMW K 1200 LT 1999 Repair Manual

1
7
Removing and installing locking
system for front seat
– Remove left trim panel and battery cover.
....................................................See Group 46
a
– Remove rear seat.
....................................................See Group 52
a

Removing locking system

•
Unclip fuse box (5) and pull forward to remove.
•
[Seat heating] Unclip plug (6).
•
Remove screws (7) and remove lock hook com-
plete with holder.
•
Disassemble release handle (8) and remove
locking system.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
•
Tighten nut (9) to lock grip (10).
•
Route Bowden cable so as to avoid tight bends.
Removing and installing Bowden
release cable
– Open the left-hand side case.
•
Remove release grip (8).
•
Remove circlip (3) and washer (2) and disengage
Bowden cable.
51.6
2
3
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
•
Tighten nut (9) to lock grip (10).
•
Route Bowden cable so as to avoid tight bends.
•
Tension spring before engaging Bowden cable,
make sure that it is seated correctly relative to
the metal lug (arrow).
4
8
5
6
7
KL510060
9
10
KL510070