Installing Input Bevel Pinion - BMW K 1200 LT 1999 Repair Manual

Installing input bevel pinion

L
Note:
Clean the threads in the housing neck prior to as-
sembly.
33 1 510
3
•
Secure the housing centrally in holder,
BMW No. 33 1 510, using bearing stud (3).
e
Caution:
Make sure that the grub screws do not project as
otherwise the neck of the housing could be dam-
aged.
•
Seat the grub screws in holder,
BMW No. 33 1 510.
•
Using holder, BMW No. 33 1 510, clamp the
housing upright as illustrated.
•
Insert shim (2) into neck of housing.
•
Chill input bevel pinion prior to installation in re-
frigerator/freezer, or similar.
•
Heat bearing seat to 120 °C (248 °F).
L
Note:
When inserting input bevel pinion (1), make sure that
it is not tilted.
33.12
1
2
4
•
Insert input bevel pinion (1) into housing.
j
120
•
Install housing cover (5).
•
Tighten fasteners (4) in diagonally opposite se-
quence.
X
Tightening torques:
KR330160
Housing cover to housing ............................ 35 Nm
00 5 500
33 1 760
•
Clean threads of threaded ring (7).
e
Caution:
Install shaft sealing ring (6) with the sealing lips fac-
ing the input bevel pinion.
•
Oil shaft sealing ring (6) lightly and drive into
threaded ring (7) with drift, BMW No. 33 1 760,
and handle, BMW No. 00 5 500.
5
6
7
2
1
KL330070
KR330150