Removing And Installing Wiring Harness - BMW K 1200 LT 1999 Repair Manual

Removing and installing wiring
harness
– Remove left and right fairing side sections.
....................................................See Group 46
a
– Remove upper section of fairing.
d
Warning:
Comply with safety precautions when handling or
working with fuel.
– Remove fuel tank.
....................................................See Group 16
a
– Remove the intake air pipe.
– Remove the air output duct from the right-hand
radiator.
....................................................See Group 17
a
– Press radiator out of holder.
•
Release the fasteners (arrows) and remove the
cover of the electronics box.
•
Open the cable ties (arrows).
•
Disconnect plugs (1, 2) in electronics box.
3
4
KR620010
L
Note:
Fasteners (4) hold the instruments in the housing;
loosely reinstall the screws after disconnecting the
contacts (3). Make sure they are reinstalled in their
original positions.
If necessary, pull gently on the cables to release the
telltale/warning lights (5).
•
Remove telltale lights (5) and contacts (3) from
the instrument cluster.
•
Disconnect the plug for the clock.
•
Remove the wiring harness.
•
Install the new wiring harness in the correct po-
sitions.
•
Install contacts and telltale/warning lights in ac-
cordance with the cable colours.
•
From this point on, installation is the reverse of
the removal procedure.
KL610150
1
2
KL610240
5
KL620021
62.9