Removing Base Of Top Case; Removing And Installing Rear Carrier Cover - BMW K 1200 LT 1999 Repair Manual

1
L
Note:
Install plate with holes (1) as seat for rivet heads.
Install retaining clip (2) for cable as illustrated, to-
gether with plate (1).
•
Use A4.0X12 pop rivets to secure the lid of the
top case to the hinges.
•
From this point on, installation is the reverse of
the removal procedure.
X
Tightening torque:
Armrest to top case........................................ 1 Nm

Removing base of top case

3
6
5
– Remove the top case.
– Remove rear radio remote control unit (6).
....................................................See Group 65
a
– Remove the power socket from the top case to-
gether with support (5) and pull cable out of top
case.
....................................................See Group 61
a
•
Drill out rivets in base of top case.
•
Remove base of top case.
•
Remove shanks of rivets and metal chips.
•
Use A4.0X12 pop rivets (4) to secure the base of
the top case to the hinges (3).
•
From this point on, installation is the reverse of
the removal procedure.
46.30
Removing and installing rear carrier
cover
– Remove the top case.
2
KL460370
•
Take out screws (7, 8).
•
Remove the rear carrier cover.
•
Installation is the reverse of the removal proce-
dure.
X
Tightening torques:
Rear carrier cover to rear frame, top .............. 9 Nm
Rear carrier cover to case .............................. 1 Nm
4
KL460162
7
8
KL460122