Assembling engine
Installing conrods
11 2 500
•
Clamp crankshaft in a vise with protective jaws.
•
Oil the big end bolts, screw them in by hand and
tighten with tightening angle indicator,
BMW No. 11 2 500.
e
Caution:
Oil the bearings.
Make sure that conrods and bearing shells are re-
installed in their original positions.
Always use new big end bolts.
Use a felt-tipped pen or similar to mark the installed
positions on the conrods.
X
Tightening torque:
Big end bolts (oiled)
Joint torque.................................................. 20 Nm
Wrench angle .................................................... 80°
RS110370
11.43