BMW K 1200 LT 1999 Repair Manual page 101

2
1
Disassembling/assembling
intermediate flange
Removing the driver bearing
•
Remove thrust plate (1).
•
Remove cup spring (2).
•
Remove ball bearing (3) with puller,
BMW No. 00 8 570, and internal puller 21/3,
BMW No. 00 8 574.
•
Remove retaining ring (4).
Installing driver bearing
•
Install retaining ring (4).
L
Note:
Use temperature measuring device,
BMW No. 00 1 900, to check heat rise.
•
Heat the intermediate flange at the bearing seat
to approx. 120 °C (248 °F).
•
Press the ball bearing into the bore until seated
against retaining ring.
11.30
4
3
•
Insert the cup spring with the larger diameter fa-
cing the bearing.
•
Install the thrust plate with the large cutout at the
top.
X
Tightening torque:
Thrust plate
(clean thread + Loctite 243)............................ 9 Nm
KR110120
KR110130