Replacing brake pads
Front brake
e
Caution:
Do not separate the two halves of the brake calliper.
Do not scrape the wheel – mask it off if necessary.
–
Remove the brake calliper.
1
2
•
Remove the split-pin keeper (1) from retaining
pin (2).
•
Remove retaining pin (2).
•
Remove brake pads by pulling downwards.
00.46
34 1 500
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
•
Before installing the brake calliper, force the pis-
tons fully back with resetting tool,
BMW No. 34 1 500.
•
Check the function of the brake system.
e
Caution:
KR340270
The fluid level in the brake fluid reservoir must be at
the "MAX" mark after the brake pads have been
changed. It is not possible to check the maximum fill
level at the inspection glass. See Checking the
front brake fluid level for the procedure.
X
Tightening torque:
Brake calliper to fork tube ............................ 40 Nm
KL000080