Removing And Installing Electronics Box - BMW K 1200 LT 1999 Repair Manual

Removing and installing electronics
box
e
Caution:
Disconnect ground lead from battery and insulate.
– Remove left and right fairing side sections.
d
Warning:
Comply with safety precautions when handling or
working with fuel.
– Remove fuel tank.
....................................................See Group 16
a
– Remove Motronic control unit.
....................................................See Group 13
a
– Remove the right-hand air intake pipe.
– Remove the air output from the right-hand radia-
tor.
– Press the right radiator forward out of its holder.
•
Release the nine fasteners (arrows). Take off
both covers.
1
2
•
Pull out relay holder (1) and plug holder (2).
•
Open the cable ties (arrows).
61.14
3
•
Disconnect ground cable (4).
•
Remove screw (3) securing connector strip for
Motronic control unit.
•
Remove the seal at the rear and push the con-
nector strip inwards.
KL610140
•
Remove screws (5, 6, 7).
•
Remove brake lines from holder on housing.
•
Removing housing.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
e
Caution:
Make sure that the seal in the cover of the electron-
ics box is correctly seated.
X
Tightening torques:
Electronics box to main frame ........................ 9 Nm
KL610130
5
6
7
4
KR610040
KL610120