Assembling engine
Installing conrod
11 2 210
•
Clamp crankshaft in a vise provided with protec-
tive jaws.
•
Oil the big end bolts, screw them in by hand and
tighten with angle gauge, BMW No. 11 2 210.
e
Caution:
Oil the bearings.
Do not accidentally confuse conrods or bearing
shells.
Always use new big end bolts.
Installed direction of conrods: ..lettering facing up
X
Tightening torque:
Big end bolts (oiled)
Joint torque.................................................. 20 Nm
Wrench angle .................................................... 80°
RS110370
11.45