Disassembling and assembling side
stand
•
Disconnect the tension springs and take off the
plate with the springs.
•
Remove switch for side stand (arrow).
...................................................See Group 61,
a
Replacing side stand switch
•
Remove fastener and remove side stand.
•
Installation is the reverse of the removal proce-
dure.
e
Caution:
Install screw and nut with Loctite 243.
Lubricant:
for pivot bushing ........................ Shell Retinax EP 2
X
Tightening torque:
Side stand to pivot mount
(clean thread + Loctite 243).......................... 41 Nm
Switch to side stand
(clean thread + Loctite 243)............................ 7 Nm
Removing and installing main
(centre) stand
See Group 00, Lubricating main stand
Removing and installing intake air
pipe
d
Warning:
Comply with safety precautions when handling or
working with fuel; note that the fuel lines are pressu-
rised.
•
Remove fuel tank.
...................................................See Group 16.
a
KR460260
1
•
Remove fasteners securing intake air pipe from
fairing bracket (2) and right-hand radiator
holder (1).
•
Remove fastener (3) at intake air silencer.
•
Remove the intake air pipe.
•
Installation is the reverse of the removal proce-
dure.
X
Tightening torques:
Intake air pipe to fairing bracket ................... 10 Nm
Intake air pipe to radiator holder................... 10 Nm
2
KL460350
3
KR130240
46.25