BMW K 1200 LT 1999 Repair Manual page 109

•
Mate the two halves of the housing.
•
Insert screws (4) for shouldered bearing and
screws (3) for needle roller bearing, and tighten
alternately.
•
Tighten the screws for the lower part of the
crankcase.
X
Tightening torque:
Shouldered bearing...................................... 40 Nm
Needle roller bearing .................................... 20 Nm
Lower part of crankcase............................... 10 Nm
Installing oil mesh strainer
•
Install a new O-ring (arrow) and place oil mesh
strainer (1) in position.
Installing oil filter
•
Coat the oil filter sealing ring with oil.
•
Install the oil filter (2), using oil-filter wrench,
BMW No. 11 4 650.
X
Tightening torque:
Oil mesh strainer .......................................... 10 Nm
Oil filter......................................................... 11 Nm
11.38
1
2
4
Installing oil sump
•
Check that sealing face is clean and degreased
and apply a thin coat of Omni VISC 1002, see
black line on sealing face with grey shading.
•
Install oil sump and cover for oil filter, if necessa-
ry.
X
Tightening torque:
Oil sump ...................................................... 10 Nm
Oil filter cover ............................................... 10 Nm
Oil drain plug................................................ 30 Nm
3
KR110440
KL110260