1
Removing and installing front
mudguard
Removing and installing front
mudguard front section
•
Release fasteners (3).
•
Release fasteners (1).
•
Remove front section of front mudguard.
•
Remove bushes (4).
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
•
Install securing screws (3).
•
Tighten securing screws (1).
•
Align the two sections of the front mudguard and
tighten securing screws (3).
X
Tightening torques:
Front mudguard, front,
to fork slider bridge (1) M 6 ............................ 4 Nm
Front mudguard, front and rear sections,
to fork slider bridge (3) M 6 ............................ 6 Nm
2
3
Removing and installing front
mudguard rear section
•
Release the fastener (2).
•
Remove the rear section of the front mudguard.
•
Installation is the reverse of the removal proce-
dure.
X
Tightening torque:
Mudguard rear section
to fork slider bridge (2) M 6
(clean thread + Loctite 243)............................ 3 Nm
4
KL460100
46.21