Rear Lights - BMW K 1200 LT 1999 Repair Manual

High (main) beam headlight
1
•
Disconnect plug (1).
•
Bend back the ground clip (2) of the bulb for
high-beam headlight and remove the bulb
holder.
•
Use a screwdriver to press in the retaining lugs
on left and right and disassemble the bulb
holder.
•
Remove the H3 bulb from its ring.
•
Installation is the reverse of the removal proce-
dure.
Bulb, parking light
•
Working from in front, pull the bulb holder (arrow)
down and out of the headlamp housing and re-
place the bulb.
•
Push the bulb holder home into its mount.
Front turn signal
•
Release the fastener and remove the turn signal.
•
Change the bulb.
63.6

Rear lights

•
Open side case on left or right, as appropriate.
2
KL630030
•
Release the fastener (arrow) and remove the tail-
light unit.
•
Replace the appropriate bulb.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
e
Caution:
When changing the rear and brake light bulbs, do
not accidentally confuse their contacts.
3
5
KL630040
Colours of the wires in the socket for tail light/
brake light
grey-yellow (3)
brown (4)
grey-blue (5)
L
Note:
Make sure that the gap between the tail-light unit
and the side case on left and right is uniform.
KL630050
4
KR630070