BMW K 1200 LT 1999 Repair Manual page 127

2
1
5
6
Installing the magnetic gate
•
Place adjusting disc (4) and rotor (3) on crank-
shaft, and tighten.
•
Install magnetic gate (2) in the same position as
previously marked.
•
Install screws (1) with washers and semi-circular
washers and tighten.
•
Reconnect the plug connector in the electronic
equipment box.
•
Reinstall cables in their original positions and
use cable ties to secure.
•
Install the cover on the electronic equipment
box.
X
Tightening torques:
Rotor .............................................................. 4 Nm
Magnetic gate ................................................ 6 Nm
e
Caution:
Correct the ignition timing.
12.6
4
3
Installing the cover of the Hall-effect
transmitter
1
•
Run the cable to the magnetic gate through the
timing case cover with a rubber sleeve (7).
•
Secure the cables for the oil pressure telltale and
temperature indicator with clip (8).
•
Install cover (6) with gasket (5).
•
From this point on, installation is the reverse of
the removal procedure.
X
Cover of Hall-effect transmitter....................... 9 Nm
8
Tightening torque:
KR110200
7
KR610280