Removing And Installing Right Grip Tube - BMW K 1200 LT 1999 Repair Manual

7
9 8
Removing and installing right grip
tube
– [With heated grip] Remove left and right fairing
side sections.
....................................................See Group 46
a
– [With heated grip] Remove tank cover.
– [With heated grip] Remove handlebar trim.
– [With heated grip] Remove fork bridge cover.
•
[With heated grip] Disconnect plug (9) for the
heated grip.
•
[With heated grip] Pull cable shoe (8) out of
connector.
•
Remove cover (3) for throttle-cable relay.
•
Remove lower cover (5).
•
Remove screws (1, 7) and remove multi-function
switch (6) from brake-lever fitting.
•
Disengage Bowden cables at cam disc (2).
•
Remove throttle-cable relay (4).
•
[With heated grip] Turn grip all the way forward
and pull it off handlebar, feeding cable through
bore (arrow) until clear.
•
Turn grip all the way forward and pull it off han-
dlebar.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
32.6
1
6
5
e
Caution:
Make sure lines and Bowden cables are routed cor-
rectly; secure lines with cable ties (arrows).
•
Check throttle cable play, adjust if necessary.
....................................................See Group 00
a
Settings:
[Without cruise control system]
throttle-cable play, engine warm ... 0.5 mm (0.02 in)
[With cruise control system]
total play at throttle twist grip,
engine warm .... 1 mm ... 1.5 mm (0.04 in ... 0.06 in)
2
3
4
KL320041
KL320110