9
Installing the engine spoilers
•
Install the socket (3) with nut in the left-hand en-
gine spoiler.
•
Install rubber clip-on nuts (1) at rear of each side
spoiler.
•
Install three clip-on nuts (6) in each side
spoiler (5, 9).
•
Position four clip-on nuts (7) in the centre engine
spoiler (8).
•
Install the left engine spoiler (5).
•
Insert the connector (2) for the socket (3) into the
left engine spoiler.
•
Install the right engine spoiler (9).
•
Install the centre engine spoiler (8) paying partic-
ular attention to the corner (see arrow).
X
Tightening torque:
Spoiler sections ............................................. 2 Nm
Installing the reverser control
•
Install actuating control for reverser (4) in left
spoiler; install the control in the drive position, in
other words with projection at top.
•
Install Torx screw (T 25) to secure actuating lever
for reverser.
X
Tightening torque:
Actuating control
for reverser .............................6 Nm (+ Loctite 243)
8
7
6
Installing the skirts
•
•
•
•
X
Fairing ............................................................ 2 Nm
1
5
14
Position two plug-in nuts (12) on the skirt (10).
Install the skirt to the skirt bracket.
Tighten the three screws (11, 14).
Install the skirt cover (13).
Tightening torques:
3
2
4
KL460110
10
11
12
13
KL460200
00.29