Removing and installing fuel
injection rail
–
Remove left and right fairing side sections.
....................................................See Group 46
a
d
Warning:
Comply with safety precautions when handling or
working with fuel; note that the fuel lines are pressu-
rised.
–
Remove fuel tank.
....................................................See Group 16
a
•
Remove air outlet duct for left radiator.
1
13 3 010
•
Use hose clamps, BMW No. 13 3 010, to close
off fuel hoses (4).
•
Slacken hose clamps securing fuel hoses and
disconnect fuel hoses.
•
Remove vacuum hose from cable ties (1, 3) and
slacken cable ties.
•
Disconnect all four plugs of injection valves (2).
•
Slacken screws and remove fasteners.
•
Pull the injection rail with the injectors out of the
intake stubs.
2
3
4
13 3 010
KR130211
KR130220
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
L
Note:
Make sure that the O-ring at the injector is in good
condition. Lightly oil the O-rings.
X
Tightening torques:
Fuel injection rail to cylinder head .................. 9 Nm
Removing and installing injectors
1
5
L
Note:
It is not necessary to slacken the cable ties (1, 3).
–
Remove fuel injection rail.
•
Slacken clamp (5) at fuel injector and remove fuel
injector.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
L
Note:
Make sure that the O-ring at the injector is in good
condition.
Note the correct installed position of the injectors.
3
KR130051
13.7