BMW K 1200 LT 1999 Repair Manual page 392

52
1
Removing and installing seat
Removing and installing front seat with
bridge
– Remove left and right fairing side sections.
– Remove tank cover.
•
[Seat heating] Disconnect plug for seat heating.
•
Remove 5 screws (arrows) and remove seat and
bridge.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
•
Note rubber washer (1) and grommet (2).
X
Tightening torques:
Bridge, seat to frame M 6............................... 9 Nm
Bridge, seat to frame M 8............................. 21 Nm
2
Removing and installing rear seat
– Lift the seat at the front.
•
Remove 2 screws and remove seat.
•
[Seat heating] Disconnect plug for seat heating.
•
Installation is the reverse of the removal proce-
dure.
X
Tightening torques:
Seat to rear frame .......................................... 9 Nm
Removing and installing rear seat
backrest
– Open the top case.
•
Remove 4 screws and remove backrest.
•
Installation is the reverse of the removal proce-
dure.
X
Tightening torques:
Seat backrest to top case .............................. 5 Nm
KL460040
52.3