Removing, Disassembling, Reassembling And Installing Rear Wheel Drive; Removing Rear Wheel Drive - BMW K 1200 LT 1999 Repair Manual

Removing, disassembling,
reassembling and installing rear
wheel drive
– Remove rear wheel.
....................................................See Group 36
a
– Remove the inductive signal transmitter.
....................................................See Group 61
a
– Remove the brake caliper.
....................................................See Group 34
a
– Remove the rear wheel brake caliper and, fasten
to the rear frame with the inductive sensor using
a cable tie.
– Remove brake disc.
....................................................See Group 34
a

Removing rear wheel drive

5
4
1
2
3
e
Caution:
Do not lay oil-filled rear-wheel drive on its side prior
to installation, as this will cause oil to escape when
the motorcycle is on the road (suction effect).
•
Unscrew the oil filler plug (1).
•
Remove oil drain plug (2) and drain oil into a suit-
able container.
•
Loosen reaction link (3) at the rear wheel drive.
•
Release clamping strap (5).
6
d
Warning:
Note high release torques for locknut and fixed
bearing stud.
•
Loosen floating bearing stud (6) and locknut (7).
•
Loosen fixed bearing stud (4).
•
Slacken floating bearing stud (6) with locknut (7)
and fixed bearing stud (4).
L
Note:
Note inner races of needle bearings.
•
Detach reaction link (3) at rear wheel drive.
•
Disconnect rear wheel drive from drive shaft.
KL330010
7
KL330020
33.7