Assembling engine
11 00 103
–
Install the gearbox.
...................................................See Group 23.
a
Installing crankshaft and
11 21 511
balancing shaft
•
Secure right side of engine housing in engine
bracket with magnet side facing downwards.
1
•
Install balancing shaft in engine housing;
marking (1) must be aligned with marking (3) on
housing.
•
Coat 1.0 mm (0.04 in) thrust washer with oil and
install on crankshaft.
•
Rotate crankshaft before installing, so that
marking (2) is aligned with marking (3).
•
Fit gasket.
•
Oil thrust washers and install on crankshaft and
balancing shaft.
L
Note:
Oil shaft bearing points.
Re-shim the crankshaft and balancing shaft if the
housing or either of the shafts was renewed.
•
Coat the balancing shaft bearing journals with
Optimoly MP 3.
Shimming crankshaft
2
3
•
Using depth gauge, BMW No. 00 2 550, meas-
ure distance from crankshaft web to housing
joint line = dimension "B".
E110330
•
Measure distance from left engine housing joint
face to spacing washer contact face = dimension
"A".
–
Dimension "A" minus dimension "B" = crankshaft
endplay.
B
F111041
A
F111050
11.45