Vpn-Target (Vpn Instance View) - HP 5800 series Command Reference Manual

undo tunnel select-seq
View
Tunneling policy view
Default level
2: System level
Parameters
cr-lsp: Specifies CR-LSP tunnels.
lsp: Specifies LSP tunnels.
load-balance-number number: Specifies the number of tunnels for load balancing. The number parameter
is ranging from 1 to 8.
Examples
# Define a tunneling policy, specifying that only LSP tunnels are used and the number of tunnels for load
balancing be 2.
<Sysname> system-view
[Sysname] tunnel-policy po1
[Sysname-tunnel-policy-po1] tunnel select-seq lsp load-balance-number 2

vpn-target (VPN instance view)

Description
Use the vpn-target command to configure VPN targets for a VPN instance.
Use the undo vpn-target command to remove the specified or all VPN targets of a VPN instance.
By default, no VPN targets are configured for a VPN instance. You must configure VPN targets when
creating a VPN instance.
• VPN targets configured in VPN instance view is applicable to both the IPv4 VPN and the IPv6 VPN.
• VPN targets configured in IPv4 VPN view is applicable to only the IPv4 VPN.
VPN targets configured in IPv4 VPN view takes precedence over that configured in VPN instance
•
view. If you configure VPN targets in both IPv4 VPN view and VPN instance view, those configured
in IPv4 VPN view are applied to the IPv4 VPN.
Syntax
vpn-target vpn-target&<1-8> [ both | export-extcommunity | import-extcommunity ]
undo vpn-target { all | vpn-target&<1-8> [ both | export-extcommunity | import-extcommunity ] }
View
VPN instance view, IPv4 VPN view
Default level
2: System level
Parameters
vpn-target&<1-8>: Adds VPN target extended community attributes to the import VPN target extended
community attribute list (Import Target) or export VPN target extended community attribute list (Export
Target). &<1-8> means that you can add up to eight VPN targets.
343