Vpn-Instance-Capability Simple; Vpn-Target - HP 5800 series Command Reference Manual

specified threshold, the system gives an alarm message but still allows new routes. If the number of routes
in the VPN instance reaches the maximum supported, no more routes are added.
simply-alert: Specifies that when the number of routes exceeds the maximum number of routes supported,
the system still accepts routes but generates a Syslog message.
Examples
# Specify that VPN instance vpn1 supports up to 1000 routes and can receive new routes after the
number of existing routes exceeds the limit.
<Sysname> system-view
[Sysname] ip vpn-instance vpn1
[Sysname-vpn-instance-vpn1] route-distinguisher 100:1
[Sysname-vpn-instance-vpn1] routing-table limit 1000 simply-alert

vpn-instance-capability simple

Description
Use the vpn-instance-capability simple command to enable multi-VPN-instance CE.
Use the undo vpn-instance-capability command to disable the function.
By default, the function is disabled.
Syntax
vpn-instance-capability simple
undo vpn-instance-capability
View
OSPF multi-instance view
Default level
2: System level
Parameters
None
Examples
# Enable multi-VPN-instance CE.
<Sysname> system-view
[Sysname] ospf 100 vpn-instance vpna
[Sysname-ospf-100] vpn-instance-capability simple

vpn-target

Description
Use the vpn-target command to configure VPN targets for a VPN instance.
Use the undo vpn-target command to remove the specified or all VPN targets of a VPN instance.
By default, no VPN targets are configured for a VPN instance. You must configure VPN targets when
creating a VPN instance.
VPN targets configured in IPv4 VPN view is applicable only to the IPv4 VPN.
•
29