Mpls Te Reoptimization (User View); Mpls Te Resv-Style - HP 5800 series Command Reference Manual

Parameters
frequency seconds: Specifies reoptimization frequency, ranging from 1 to 604,800 seconds. The default
is 3600 seconds, or 1 hour.
Examples
# Enable reoptimization, setting the reoptimization (automatic rerouting) frequency to 43,200 seconds (12
hours).
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te reoptimization frequency 43200

mpls te reoptimization (user view)

Description
Use the mpls te reoptimization command to start reoptimizing all reoptimization-enabled TE tunnels.
Syntax
mpls te reoptimization
View
User view
Default level
2: System level
Parameters
None
Examples
# Start reoptimizing all reoptimization-enabled TE tunnels.
<Sysname> mpls te reoptimization

mpls te resv-style

Description
Use the mpls te resv-style command to set the resource reservation style for the MPLS TE tunnel.
Use the undo mpls te resv-style command to restore the default.
The default resource reservation style is SE.
You may configure FF and SE only when the signaling protocol is set to RSVP-TE.
Syntax
mpls te resv-style { ff | se }
undo mpls te resv-style
View
Tunnel interface view
Default level
2: System level
186