Display Mpls Te Tunnel Path - HP 5800 series Command Reference Manual

Field
ExcludeAllAff
IncludeAllAff
Created Time

display mpls te tunnel path

Description
Use the display mpls te tunnel path command to display the path or paths that the specified or all MPLS
TE tunnels traverse on this node.
Syntax
display mpls te tunnel path [ lsp-id lsr-id lsp-id | tunnel-name tunnel-name ] [ | { begin | exclude |
include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
lsr-id: Specifies the ingress LSR ID, in dotted decimal notation.
lsp-id: Specifies the LSP ID, ranging from 1 to 65,535.
tunnel-name tunnel-name: Specifies the tunnel name, which is a string of 1 to 63 characters.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case-sensitive string of 1 to 256 characters.
Examples
# Display the paths that all MPLS TE tunnels traverse.
<Sysname> display mpls te tunnel path
Tunnel Interface Name : Tunnel0
Lsp ID : 1.1.1.9:10
Hop information:
Hop 0: 192.1.1.1;
Hop 1: 12.1.1.2;
Hop 2: 10.202.2.2.
Description
Link properties that are excluded
All link affinity properties that must be included
Time when the tunnel was created
148