HP 5800 series Command Reference Manual page 357

Connect-interface has been configured
Peer Preferred Value: 0
BFD: Enabled
Routing policy configured:
No routing policy is configured
Table 136 Command output
Field
Peer
Local
Type
BGP version
remote router ID
BGP current state
Up for
BGP current event
BGP last state
Port
Configured
Received
Negotiated
Peer optional capabilities
Peer support bgp multi-protocol
extended
Peer support bgp route refresh
capability
Address family IPv4 Unicast
Address family VPNv6
Received
Sent
Maximum allowed prefix number
Threshold
Minimum time between
advertisement runs
Optional capabilities
Description
IP address of the peer.
IP address of the local router.
BGP type.
Version of BGP that the peer runs.
Router ID of the remote router.
Current state of the BGP session.
Duration since the peer is established.
Current event of the BGP session.
State that the BGP session was in before transitioning to the current
state.
Local and remote ports of the BGP session.
Settings of the local timers, including the active hold interval and
keepalive interval.
Received active hold interval.
Negotiated active hold interval.
Optional capabilities of the peer.
The peer supports multiprotocol extension.
The peer supports route refreshing.
IPv4 unicast family capability.
VPNv6 address family capability.
Total number of received messages and the number of received update
messages.
Total number of sent messages and the number of sent update
messages.
Maximum number of routes that the VPN instance supports.
Threshold for warning. When the percentage of the number of the
received route prefixes to the maximum number of routes supported
reaches this value, the device generates a prompt.
Minimum interval between route advertisements.
Local optional capabilities.
348