Display Ospf Mpls - HP 5800 series Command Reference Manual

Field
BackUpBW
Route Pinning
Retry Limit
Retry Interval
Reopt
Reopt Freq
Back Up Type
Back Up LSPID
Auto BW
Auto BW Freq
Min BW
Max BW
Current Collected BW
Interfaces Protected
VPN Bind Type
VPN Bind Value
Car Policy
Tunnel Group
Primary Tunnel
Backup Tunnel
Group Status
Oam Status
display ospf mpls-te
Description
Use the display ospf mpls-te command to display TE LSAs in the LSDB.
Syntax
display ospf [ process-id ] mpls-te [ area area-id ] [ self-originated ] [ | { begin | exclude | include }
regular-expression ]
View
Any view
Default level
1: Monitor level
Description
Backup bandwidth
Route pinning function
Maximum number of setup retries
Retry interval
State of the reoptimization function
Reoptimization interval
Backup path type
Backup LSP ID
State of the automatic bandwidth adjustment function
Automatic bandwidth adjustment interval
Lower limit for automatic bandwidth adjustment
Upper limit for automatic bandwidth adjustment
Bandwidth information collected
FRR protected interfaces
Type of the binding, VPN or ACL
Value of the binding, the VPN instance name or ACL number
Whether CAR policy is enabled
Whether the tunnel is the primary tunnel or backup tunnel in the
group.
Tunnel ID of the primary tunnel. If the tunnel is the primary tunnel, – is
displayed for this field.
Tunnel ID of the backup tunnel. If the tunnel is the backup tunnel, – is
displayed for this field.
Status of the group. Displayed as - if no protection group is
configured.
OAM defect detection status. – means OAM is not enabled.
152