Display Mpls Label - HP 5800 series Command Reference Manual

Examples
# Display brief MPLS-related information about all interfaces with MPLS enabled.
<Sysname> display mpls interface
Interface
Vlan1
Vlan2
# Display detailed MPLS related information about MPLS-enabled interface Vlan-interface 2.
<Sysname> display mpls interface vlan-interface 2 verbose
No
Interface
Status
TE Attribute
LSPCount
CR-LSPCount
FRR
Table 21 Command output
Field
TE Attr/TE Attribute
LSP Count/LSPCount
CR-LSP Count/CR-LSPCount
FRR
NOTE:
For information about FRR, see the

display mpls label

Description
Use the display mpls label command to display usage information about specified labels or all labels.
Syntax
display mpls label { label-value1 [ to label-value2 ] | all } [ | { begin | exclude | include } regular-
expression ]
View
Any view
Default level
1: Monitor level
Parameters
label-value1: Specifies a label, or, when used with the label-value2 parameter, the start label of a range
of labels. The value of this parameter ranges from 16 to 204,799.
Status TE Attr
Up En
Up En
: 1
: Vlan2
: Down
: Disable
: 0
: 0
: Disabled
MPLS Configuration Guide
LSP Count CRLSP Count
0 0
0 0
Description
Whether TE is enabled on the interface.
Number of LSPs on the interface.
Number of CR-LSPs on the interface.
Whether FRR is enabled on the interface. If FRR is
enabled, the output will also include the bound
tunnels.
.
55