Display Bgp Vpnv6 Vpn-Instance Routing-Table - HP 5800 series Command Reference Manual

Field
BGP version
remote router ID
BGP current state
Up for
BGP current event
BGP last state
Port
Configured
Received
Negotiated
Peer optional capabilities
Peer support bgp multi-protocol
extended
Peer support bgp route refresh
capability
Address family IPv6 Unicast
Received
Sent
Maximum allowed prefix number
Threshold
Minimum time between
advertisement runs
Optional capabilities
Route refresh capability
Peer Preferred Value

display bgp vpnv6 vpn-instance routing-table

Description
Use the display bgp vpnv6 vpn-instance routing-table command to display the BGP VPNv6 routing
information of the specified VPN.
Description
Version of BGP that the peer runs.
Router ID of the peer.
Current state of the BGP session.
Duration since the peer is established.
Current event of the BGP session.
State that the BGP session was in before transitioning to the current
state.
Local and remote ports of the BGP session.
Settings of the local timers, including the active hold interval and
keepalive interval.
Received active hold interval.
Negotiated active hold interval.
Optional capabilities of the peer.
The peer supports multiprotocol extension.
The peer supports route refreshing.
IPv6 unicast family capability.
Total number of received messages and the number of received update
messages.
Total number of sent messages and the number of sent update
messages.
Maximum number of routes that the VPN instance supports.
Threshold for warning. When the percentage of the number of the
received route prefixes to the maximum number of routes supported
reaches this value, the device generates a prompt.
Minimum interval between route advertisements.
Local optional capabilities.
Whether route refreshing is enabled.
Preference value specified for routes from the peer.
355