Display Tunnel-Info - HP 5800 series Command Reference Manual

Configuration:
Neighbor Ip Address: 100.0.0.2
Cost
Cost Type
Hold time
Table 72 Command output
Field
Interface
Type
Neighbor ID
State

display tunnel-info

Description
Use the display tunnel-info command to display information about tunnels.
Syntax
display tunnel-info { tunnel-id | all | statistics } [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
tunnel-id: Specifies a tunnel ID, ranging from 1 to FFFFFFFE. If you specify a tunnel, only information
about this tunnel is displayed.
all: Display information about all tunnels.
statistics: Displays statistics about tunnels.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case-sensitive string of 1 to 256 characters.
Examples
# Display information about all tunnels.
<Sysname> display tunnel-info all
Tunnel ID
------------------------------------------------------
: -10
: Relative
: 10s
Description
Tunnel interface address and name
Approach to automatic route advertisement: IGP shortcut or
forwarding adjacency
Remote neighbor ID
State: up or down
Type Destination
155