Mpls Te Path Metric-Type - HP 5800 series Command Reference Manual

View
Tunnel interface view
Default level
2: System level
Parameters
dynamic: Uses the dynamically calculated path.
explicit-path pathname: Uses an existing explicit path. The pathname parameter is a case-insensitive
string of 1 to 31 characters.
preference value: Specifies the preference of the path. The value parameter is ranging from 1 to 10. The
smaller the value, the higher the preference.
Examples
# Configure interface Tunnel 0 to use the explicit path named path1 and the dynamically calculated path,
setting the preferences of the paths to 1 and 2, respectively.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te path explicit-path path1 preference 1
[Sysname-Tunnel0] mpls te path dynamic preference 2

mpls te path metric-type

Description
Use the mpls te path metric-type command in MPLS view to specify the link metric type used for path
calculation when a metric type was not explicitly configured for a tunnel.
Use the mpls te path metric-type command in tunnel interface view to specify the link metric type used for
path calculation of the current tunnel.
Use the undo mpls te path metric-type command to restore the default. This undo form is only available in
tunnel interface view.
In MPLS view, TE metrics of links are used in path calculation for TE tunnels by default.
In tunnel interface view, no link metric type is specified for path calculation by default.
A tunnel prefers the link metric type specified in the tunnel interface view. If no link metric type is specified
in tunnel interface view, the configuration in MPLS view is used.
Related commands: mpls te metric.
Syntax
mpls te path metric-type { igp | te }
undo mpls te path metric-type
View
MPLS view, tunnel interface view
Default level
2: System level
182