Mpls Rsvp-Te Authentication - HP 5800 series Command Reference Manual

Parameters
None
Examples
# Enable RSVP-TE on current node.
<Sysname> system-view
[Sysname] mpls
[Sysname-mpls] mpls te
[Sysname-mpls] mpls rsvp-te
# Enable RSVP-TE on VLAN-interface 1.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] mpls
[Sysname-Vlan-interface1] mpls te
[Sysname-Vlan-interface1] mpls rsvp-te

mpls rsvp-te authentication

Description
Use the mpls rsvp-te authentication command to enable RSVP message authentication on the interface.
Use the undo mpls rsvp-te authentication command to disable RSVP message authentication on the
interface.
The RSVP messages sent out of the interface convey a message authentication digest created using the
hash algorithm and the configured authentication key. This authentication key is also used by the interface
to authenticate received RSVP messages. For the two interfaces at the two ends of a link to exchange
RSVP messages, they must share the same authentication key.
This hop-by-hop authentication of RSVP is to prevent fake resource reservation requests from occupying
network resources.
The RSVP message authentication and Fast Reroute are mutually exclusive.
Syntax
mpls rsvp-te authentication { cipher | plain } auth-key
undo mpls rsvp-te authentication
View
Interface view
Default level
2: System level
Parameters
cipher: Indicates that the specified authentication key is a cipher-text key.
plain: Indicates that the specified authentication key is a plain-text key.
auth-key: Specifies the authentication key, case sensitive. Input in plain text, the string for it is 8 to 16
characters in length. Input in cipher text, the string for it is 24 characters in length. If you specify the plain
keyword, you can only input it in plain text. If you specify the cipher keyword, you can input it in either
plain text or in cipher text.
160