HP 5800 series Command Reference Manual page 211

Field
remote router ID
BGP current state
BGP current event
BGP last state
Port
Configured
Received
Negotiated
Peer optional capabilities:
Peer support bgp multi-protocol extended
Peer support bgp route refresh capability
Graceful Restart Capability:
Restart Timer Value of Peer
Forwarding State preserved by Peer for following
Address families
Address family IPv4 Unicast
Address family VPLS
Received
Sent
Maximum allowed prefix number
Threshold
Minimum time between advertisement runs is XX
seconds
Optional capabilities:
Route refresh capability has been enabled
Connect-interface has been configured
Peer Preferred Value
BFD
Routing policy configured
# Display the VPLS information for RD 100:1 in the BGP routing table.
<Sysname> display bgp vpls route-distinguisher 100:1
BGP Local Router ID : 2.2.2.9, Local AS Number : 100
Origin codes:i - IGP, e - EGP, ? - incomplete
Description
IP address of the remote router.
Current status of the BGP session.
Current event of the BGP session.
State that the BGP session was in before
transitioning to the current status.
Local and remote port numbers of the BGP session.
Settings of the local timers.
Received active hold interval.
Negotiated timer settings.
Optional peer capabilities. In this example, the peer
supports BGP multicast protocol extension and route
refresh.
Information about GR capability, including the peer
restart timer and the address families for which
forwarding state is preserved.
IPv4 unicast address family capability.
VPLS address family
Counts of received messages, including the total
number of received messages and the number of
received update messages.
Counts of sent messages, including the total number
of sent messages and the number of sent update
messages
Maximum number of routes allowed.
Threshold value. When the number of routes reaches
the maximum number of routes allowed multiplied
by this threshold value, an alarm is issued.
Minimum advertising interval.
Optional capabilities. In this example, route refresh
capability is enabled, and the directly connected
interface is configured.
Peer preference value.
Whether BFD is enabled for the peer.
Routing policy configured for the peer.
202