HP 5800 series Command Reference Manual page 293

Configured: Active Hold Time: 180 sec
Received : Active Hold Time: 180 sec
Negotiated: Active Hold Time: 180 sec
Peer optional capabilities:
Peer support bgp multi-protocol extended
Peer support bgp route refresh capability
Address family IPv4 Unicast: advertised and received
Address family VPNv4: advertised and received
Received: Total 52 messages, Update messages 2
Sent: Total 65 messages, Update messages 5
Maximum allowed prefix number: 150000
Threshold: 75%
Minimum time between advertisement runs is 15 seconds
Optional capabilities:
ORF advertise capability based on Prefix(type 64):
Local: both
Negotiated: send
Connect-interface has been configured
Peer Preferred Value: 0
BFD: Enabled
Routing policy configured:
No routing policy is configured
Table 120 Command output
Field
Peer
Local
Type
BGP version
remote router ID
BGP current state
Up for
BGP current event
BGP last state
Port
Configured
Received
Negotiated
Peer optional capabilities
Peer support bgp multi-protocol extended
Peer support bgp route refresh capability
Keepalive Time:60 sec
Description
IP address of the peer
IP address of the local router
BGP type
Version of BGP that the peer runs.
Router ID of the remote router.
Current status of BGP.
Duration since the peer is established.
Current event of the peer.
State that BGP was in before transitioning to the
current status.
Local and remote BGP port numbers
Settings of the local timers, including the active hold
interval and keepalive interval.
Received active hold interval.
Negotiated active hold interval.
Optional capabilities of the peer.
The peer supports multiprotocol extension.
The peer supports route refresh capability.
284