Mpls Te Loop-Detection - HP 5800 series Command Reference Manual

Use the undo mpls te link administrative group command to restore the default.
The default link administrative group attribute is 0x00000000.
The interface properties are propagated globally. They are used for path selection at the tunnel ingress.
Related commands: mpls te affinity property.
Syntax
mpls te link administrative group value
undo mpls te link administrative group
View
Interface view
Default level
2: System level
Parameters
value: Specifies the link administrative group attribute, ranging from 0x00000000 to 0xFFFFFFFF. It is a
set of 32 link properties. Each bit represents a property with a value of 0 or 1. By ANDing the
administrative group attribute bits with the link affinity attribute bits of an MPLS TE tunnel, MPLS TE
identifies the properties of the links that the MPLS TE tunnel can use.
Examples
# Assign VLAN-interface 1 the link administrative group attribute of 0x00000101.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] mpls te link administrative group 101

mpls te loop-detection

Description
Use the mpls te loop-detection command to configure the node to perform loop detection when setting up
the MPLS TE tunnel.
Use the undo mpls te loop-detection command to disable loop detection.
Loop detection is disabled by default.
Syntax
mpls te loop-detection
undo mpls te loop-detection
View
Tunnel interface view
Default level
2: System level
Parameters
None
180