Remove or replace non-stationary C-NET devices
11
Replacing non-stationary C-NET devices of different types
11.5 Replacing non-stationary C-NET devices of
11.5.1 Removing the C-NET device
11.5.2 Installing the C-NET device
11.5.3 Replacing C-NET device in the 'Zone'
110 | 118
Building Technologies
Fire Safety
different types
Procedure
●
Detach C-NET device
●
Delete C-NET device on Person Machine Interface
●
Installing a new C-NET device
●
Read in C-NET devices. This step need only be performed once.
●
Connect PC to the 'Station'
●
Load configuration from the 'Station' to the PC
●
Replace C-NET device in the 'Zone'
●
Load configuration from the PC to the 'Station'
●
Disconnect PC from the 'Station'
You will find information about the individual steps in the following chapters and the
chapters to which reference is made below.
Uninstall the device you want to replace.
κ
The 'Station' detects that the device is missing and reports a 'Fault'.
You will find more information about installing and uninstalling in the
documentation for the corresponding 'C-NET' device.
Install the new C-NET device.
You will find more information about installing in the documentation for the
corresponding 'C-NET' device.
1. Select the 'Zone' in which you have replaced a device in Cerberus-
Engineering-Tool. The 'Find' or 'Find and replace' functions can be used to do
this.
2. Replace the C-NET device.
You will find more information in document A6V10210424. See chapter 'Applicable
documents'.
A6V10211100_f_en_--
2015-12-15