Connectivity and communication with 'Station'
Connecting the PC to the station
9.2 Connecting the PC to the station
76 | 118
5. Set the following values:
'Protocol type': 'UDP'
'Local port': 'Specific Ports', and enter the value range '50067-50070' in the
'Remote port': 'All Ports'
6. Confirm with 'OK'.
The new firewall rule is now configured.
Security vulnerability in operating system due to open ports
Unauthorized access to your PC
Deactivate the firewall rule configured above after the firmware update.
For most commissioning, maintenance and repair work a PC with installed
Cerberus-Engineering-Tool is required. The figure below shows the connection
between the PC and ↑ 'Station'.
Figure 30: Rear panel of operating unit and PC
Cable, type CAT 5 or CAT 7, crossover, max. 100 m