Kp8F - Configure Shared Device For Non Fail-Safe Controller - Siemens SIMATIC KP8 Operating Instructions Manual

6.8 KP8F – Configure Shared Device for non fail-safe controller
You can also operate the KP8F with a non fail-safe controller. The non fail-safe controller
must support Shared Device in this case.
Requirement
● "HW Config" is open in the SIMATIC Manager.
Procedure
1. Perform steps 1 to 9 as described in section "KP8F – Configure Shared Device
2. Select the "Access" tab.
KP8, KP8F
Operating Instructions, 10/2010, A5E03284305-01
In the following image, the module to be configured is labeled in red.
(Page 68)".
The following dialog appears:
6.8 KP8F – Configure Shared Device for non fail-safe controller
Setting the KP8 and KP8F
71