Table of Contents
Advertisement
10.8.7 Switch off
10.8.7.1 Safety during switch-off
10.8.7.2 Switching off the detector line
10.8.7.3 Switch off zone
10.8.8 Switching on
10.8.8.1 Switch on detector line
Building Technologies
Fire Safety
WARNING
System parts that have been switched off make it impossible to acquire and
process alarms or faults!
Fire may spread unhindered.
●
Deploy staff to monitor the deactivated area.
●
You must switch deactivated parts of the 'Site' back on as soon as possible.
1. Select 'Main menu' > 'Topology' > 'Hardware tree' > ↑ 'Station' > ↑ Line card >
↑ Detector line.
2. Press the 'MoreOptions' softkey and select 'Execute commands'.
3.
WARNING! System parts that have been switched off make it impossible to
acquire and process alarms or faults! Select the 'Detector line OFF' command.
The yellow 'ISOLATION' LED lights up.
The detector line is switched off.
1. Select 'Topology' > ↑ 'Detection tree' > 'Area' > ↑ 'Section' > 'Zone' in the main
menu.
2. Press the 'More Options' softkey and select 'Execute commands'.
3.
WARNING! System parts that have been switched off make it impossible to
acquire and process alarms or faults! Select the 'Off' command.
The yellow 'ISOLATION' LED lights up.
The 'Zone' is switched off.
1. Select 'Main menu' > 'Topology' > 'Hardware tree' > 'Station' > ↑ Line card >
↑ Detector line.
2. Press the 'MoreOptions' softkey and select 'Execute commands'.
3. Select the 'Detector line ON' command.
The yellow 'ISOLATION' LED goes out.
The detector line is switched on.
Commissioning
Detailed commissioning steps
A6V10211100_f_en_--
10
99 | 118
2015-12-15
Advertisement
Table of Contents
