Plant Diagrams - Siemens LMS14 User Manual

Reset to default
parameters
Structure of check
number
Check no. heat source 1
(6212)
Check no. heat source 2
(6213)
Check no. storage tank
(6215)
Check no. heating circuits
(6217)
Building Technologies Division
Line no. Operating line
6205 Reset to default parameters
No
Yes
All resettable parameters can be reset to their default values.
Exempted from this are the following operating pages:

Time of day and date

Operator section

Wireless and all Time programs

Setpoint – Manual control
Note!
In the LMS14..., the memory area with the factory settings is only overwritten by

function
Save parameters

the ACS435 PC software together with the OCI431 interface,

the AGU2.56... parameter stick.
When the LMS14... is parameterized with ACS420 or ACS700/ACS790, only the
operating area of the parameter storage is overwritten, not the area with the
factory settings.
If, in this case, function
settings made by Siemens are reloaded.
If, after storing parameters with ACS420 and OCI430, the parameters shall be
used as factory settings, use function

6.23.27 Plant diagrams

To identify the current plant diagram, the basic unit generates a check number. This
check number is made up of the successive partial diagram numbers.
Every check number consists of 3 columns, each representing the application of a plant
component. Every column shows a number with a maximum of 2 digits. Exception is
the first column. If the first digit in the first column reads 0, the 0 is hidden.
1st column
2 digits
---
---
---
Heating circuit 3
User Manual LMS14...
6 The settings in detail
(6204),
Reset to default parameters
Save parameters
2nd column
2 digits
Solar
Solid fuel boiler
Buffer storage tank
Heating circuit 2
(6205) is used, the factory
(6204).
3rd column
2 digits
Oil/gas boiler
---
DHW storage tank
Heating circuit 1
CC1U7471en
28.01.2015
463/617