Information List - Siemens SIPROTEC 4 User Manual

Functions
2.16 Automatic Reclosing System 79
Addr. Parameter
7261 bef.3.Cy:67N-3
7262 bef.4.Cy:67-3
7263 bef.4.Cy:67N-3

Information List

2.16.8
No. Information
127 79 ON/OFF
2701 >79 ON
2702 >79 OFF
2703 >BLOCK 79
2711 >79 Start
2715 >Start 79 Gnd
2716 >Start 79 Ph
2722 >ZSC ON
2723 >ZSC OFF
2730 >CB Ready
2731 >Sync.release
2753 79 DT delay ex.
2754 >79 DT St.Delay
2781 79 OFF
2782 79 ON
2784 79 is NOT ready
2785 79 DynBlock
2788 79 T-CBreadyExp
2801 79 in progress
2808 79 BLK: CB open
2809 79 T-Start Exp
2810 79 TdeadMax Exp
2823 79 no starter
2824 79 no cycle
2827 79 BLK by trip
2828 79 BLK:3ph p.u.
2829 79 Tact expired
2830 79 Max. No. Cyc
2844 79 1stCyc. run.
2845 79 2ndCyc. run.
2846 79 3rdCyc. run.
2847 79 4thCyc. run.
258
Setting Options
Set value T=T
instant. T=0
blocked T=∞
Set value T=T
instant. T=0
blocked T=∞
Set value T=T
instant. T=0
blocked T=∞
Type of Comments
Informa-
tion
IntSP 79 ON/OFF (via system port)
SP >79 ON
SP >79 OFF
SP >BLOCK 79
SP >79 External start of internal A/R
SP >Start 79 Ground program
SP >Start 79 Phase program
SP >Switch zone sequence coordination ON
SP >Switch zone sequence coordination OFF
SP >Circuit breaker READY for reclosing
SP >79: Sync. release from ext. sync.-check
OUT 79: Max. Dead Time Start Delay expired
SP >79: Dead Time Start Delay
OUT 79 Auto recloser is switched OFF
IntSP 79 Auto recloser is switched ON
OUT 79 Auto recloser is NOT ready
OUT 79 - Auto-reclose is dynamically BLOCKED
OUT 79: CB ready monitoring window expired
OUT 79 - in progress
OUT 79: CB open with no trip
OUT 79: Start-signal monitoring time expired
OUT 79: Maximum dead time expired
OUT 79: no starter configured
OUT 79: no cycle configured
OUT 79: blocking due to trip
OUT 79: blocking due to 3-phase pickup
OUT 79: action time expired before trip
OUT 79: max. no. of cycles exceeded
OUT 79 1st cycle running
OUT 79 2nd cycle running
OUT 79 3rd cycle running
OUT 79 4th or higher cycle running
Default Setting Comments
Set value T=T before 3. Cycle: IE>>> directional
Set value T=T before 4. Cycle: 67-3
Set value T=T before 4. Cycle: 67N-3
C53000-G1140-C207-8, Edition 08.2016
SIPROTEC 4, 7SJ62/64, Manual