Siemens SIPROTEC 4 User Manual page 207

voltage 3 · V can be calculated by the device based on the three phase–to–ground voltages. In the latter case,
0
the three voltage inputs must be connected to voltage transformers in a grounded-wye configuration (see also
address 213 VT Connect. 3ph in Subsection
with phase-to-phase voltages, it is not possible to calculate a displacement voltage from them. In this case the
direction cannot be determined.
If the displacement voltage is calculated, then:
3 · V = V + V
0 A B
If the displacement voltage is directly applied to the device, then V
not affected by parameter Vph / Vdelta (address 206).
Pickup performed by the displacement voltage can be delayed (64-1 DELAY) for tripping.
It is important to note that the total trip-command time then consists of the displacement voltage measure-
ment time (about 50 ms) plus the pickup delay time 64-1 DELAY.
After the voltage element picks up due to detection of a displacement voltage, the grounded phase is identi-
fied, if possible. To do this, the individual phase-to-ground voltages are measured. Of course, this is only
possible if three phase-to-ground voltages are obtained from voltage transformers connected in a grounded
wye configuration. If the voltage magnitude for any given phase is below the setting value V
is detected as the grounded phase as long as the remaining phase-to-ground voltages are simultaneously
above the setting value V
[7sj6x_erdschlussbehaftete_phase-150502-kn, 1, en_US]
Figure 2-87
Current Elements
There are two current elements. Both elements operate directionally, whereby the tripping zones can be set
individually for each element (see margin heading "Tripping Area"). Both current elements are provided with a
definite time characteristic. Two current/time elements are used for ground fault protection. Analog to the
time overcurrent protection function, the overcurrent element is named 50Ns-1 PICKUP and 50Ns-1
DELAY and the high-set element 50Ns-2 PICKUP and 50Ns-2 DELAY.
The pickup of the definite time overcurrent protection can be stabilized by the configured dropout delay time
(address 3121 50Ns T DROP-OUT).
SIPROTEC 4, 7SJ62/64, Manual
C53000-G1140-C207-8, Edition 08.2016
+ V
C
.
Ph max
Determination of Ground-faulted Phase
2.13 Ground Fault Protection 64, 67N(s), 50N(s), 51N(s)
2.1.3 Power System Data 1). If the device is only provided
is the voltage at the device terminals. It is
0
Functions
, that phase
Ph min
207